Please follow the steps below to secure the M.2 device with the screw.
1. Please remove the mylar firstly if you would like to use a M.2 device of different length.
(If you don’t need to change the location of the standoff, please see the step 4 directly.)
2. Vertically use the Hexagon socket screwdriver to release the standoff counterclockwise.
Note: To prevent the standoff from getting stripped, please apply the proper force to Hexagon socket screwdriver when you release the standoff.
![](https://www.asrockind.com/image/catalog/asrock/FAQ/20092101/02.jpg)
3. Vertically use the Hexagon socket screwdriver to fasten the standoff into the M.2 device screw hole clockwise.
Note: Please only apply the proper force (lower than 2.5Kgf*cm) to tightly fasten the standoff.
![](https://www.asrockind.com/image/catalog/asrock/FAQ/20092101/03.jpg)
4. Install M.2 device into the slot
![](https://www.asrockind.com/image/catalog/asrock/FAQ/20092101/04.jpg)
5. Put on the screw and vertically use screwdriver to lock it clockwise.
Note: Please only apply the proper force (lower than 2.5Kgf*cm) to tightly lock the screw.
![](https://www.asrockind.com/image/catalog/asrock/FAQ/20092101/06.jpg)
|